| Basis of Credit |
Upon successful completion of the Diploma of Science (Engineering Studies) at Edith Cowan College, up to 8 units (120 Credit Points) of advanced standing may be awarded Y45.7 Bachelor of Engineering (Mechanical) Honours. NOTE: In order to complete within the indicated timeframe, enrolment overloads (ie undertaking five units in a semester) or enrolment in summer semester units may be necessary at some point during the course. CSP1150 Programming Principles has been replaced with unit CSP2151 Programming Fundamentals. If either unit has been completed at ECC student will be granted Advanced Standing for unit CSP2151. If unit ENS1115D has been successfully completed at ECC then Advanced Standing will be granted for unit ENS1115. |
|---|
| ECU Unit(s) |
| ENM1102 (Engineering Drawing and Computer Aided Design) |
| ENS1101 (Engineering Mechanics) |
| ENS1115 (Materials and Manufacturing 1) |
| ENS1154 (Introduction to Engineering) |
| ENS1180 (Introduction to Energy and Resource Engineering) |
| ENS1253 (Electrical Engineering 1B) |
| MAT1250 (Mathematics 1) |
| MAT1251 (Mathematics 2) |
| Achievement Required |
A maximum of 8 of the below unit matches may be awarded.
Should different units be selected, or the full Diploma not be completed, the full amount of advanced standing may not be granted. |
|---|
No unspecified Credit and Recognition of Prior Learning found
This precedent is an indication of potential credit only. A case-by-case review will be conducted to determine if credit can be granted. The reduction in course duration noted above, is based on the number of credit points granted as CRPL only. Students are encouraged to request a personalised course planner from the Hub, for an accurate indication of any reduction in course duration. The course planner will be based on the number of credit points granted as CRPL, the course structure itself, and will take into account how units are timetabled and any unit prerequisite requirements